Different clips to each laser

General
1

Is there a way that i can send a diferent CLIP to each laser?

example is, i Have 5 lasers
i want 2 lasers to show triangles
and 3 to show circles.

how do i do it?

2

Hi,

I would say assign the lasers to groups and send the Clip to the group.
Clip 1 —> Group 1
Clip 2 —> Group 2

Mit freundlichen Grüßen
Best regards

Stephan Beutel

3

Hi @dada and welcome! Hope you’re enjoying getting to know Liberation so far.

See the user guide for how to assign clips to particular laser zones :

And then there are a few different ways to get more than one clip running at the same time.

As @stevewallet says, if you assign different clips to different groups you can then start and stop them independently. More about clip groups :

And for more information about starting and stopping clips :

Hope this helps!

Seb

4

omg @seb i played with it all night, i fucking LOVE IT, cant wait to connect to the midi controller. Now i read the manual a couple times, i get that i can group them on group 1 for most used, and group 2 for second most used, but them group 3 they flash, i dont understand the gourp 4 and 5.

5

Thanks @dada I’m so glad you’re enjoying it!

The groups can really be set up for anything you want, and group 3 doesn’t have to be in flash mode (you can right click the group button and set this separately).

I personally try to use group 4 for more mellow clips, and 5 for graphics, but it’s entirely up to you!

Hope this helps

Seb