I tried to delete as many exact duplicates as I could, but there’s surely some still in there. After spending 30+ hours organizing this, I need a break and figured you guys would like to have this sooner rather than later.
It’s organized by:
Still/Static, Moving Dotted Beam(s), Horizontal Dotted Beams, Sine Dotted, Horizontal connected beams, Dual Angle, Vertical, Partial Circles, Dotted Circles, Connected Circles, Triangles, Squares, Sine & Sharp Edge, Sine Waves, Fast Moving & Short Duration & Strobe clips, Complex/Animated Clips, Red Zone Clips (press and hold to launch), Words & Numbers.
Theres some insane stuff here!!! My mac is handling it quite ok, but sometimes the patterns get a bit jittery, this does not affect laser output right?
@mathijslaser I have not had any output issues thus far! After organizing this many clips, I’ve found that some of the clip previews don’t accurately represent the actual output. I’m also on a Mac and no real issues. PM me example(s) of what’s showing jittery so I can check it out!
I do have a question; is there an easy way to set all clips to output to all lasers? (in my case 4 lasers for tonights gig) Or do I need to manually select each clip and enable all 4 beams?
I tried looking into putting it all in the same group and somehow adjusting it that way, but that didnt seem to work like I wanted.
Amazing, thanks!!! still, in general, is there a good way to do this inside of liberation? Is it something you were running into as well and had it laying around, or did you just now do it somehow?
Lol yeah, I get the temptation to edit the files but it could cause problems down the line and I definitely wouldn’t rely on it! It’s quite easy to accidentally break things or end up with odd side effects, especially if anything changes between versions.
The good news is there’s a built-in way to do exactly what you want using groups:
Press the group button (and keep it pressed if you’re using a MIDI controller)
Then toggle the zone buttons (BEAM 1–8 etc)
That will set the zones for all clips in that group at once, so you can very quickly enable all 4 lasers across everything.
If the zone button is flashing it means that some clips in that group have the zone set but not all of them.
If the zone button is steady on it means that all clips in that group are set
If the zone button is steady off it means that none of the clips in that group are set.
Same goes for the X/Y flip buttons. There’s a bit more detail in the user guide :
Here’s an updated deck. No clips added since the 03.17.26v2 upload; however, more exact duplicates were deleted, but mostly, the deck is much more organized… 9 additional hours organized…
Here’s the most updated version with additional clips added (dug through the forum to find some of @seb old stuff that’s still pretty great. Probably close to 50 hours into organizing this thing at this point.. Organization is the same and a work in progress.
It’s quite easy to accidentally break things or end up with odd side effects, especially if anything changes between versions.